How to Turn a Mini Educator Into a Two-Dog System

 

The Mini Educator (ET-300) can control two dogs with one remote. You don’t need to buy a new system—just add a second receiver and follow these steps.

---

What You Need

• 1 Mini Educator ET-300 remote

• 2 Mini Educator receivers (collars)
  

---

Step 1: Unlock the Remote

Before pairing, make sure the remote is unlocked.

• Hold the level dial/ lock button until 1D is flashing

• The remote must be unlocked to change modes and pair collars

---

Step 2: Set the Stimulation Level to 0

• Turn the dial down so the display reads 0
  

---

Step 3: Change From 1D to 2D Mode

• Click & hold black (s), red (s), & black (t) until you see numbers flash

• You should hear a beep

---

Step 4: Pair Dog 1

• Touch the red pairing dot from the remote to the collar & hold until the collar is continuously flashing green

• Press & hold black (s), then press & hold red (s) at the same time

• This collar is now paired to the black (s) 

---

Step 5: Pair Dog 2

• Touch the red pairing dot from the remote to the collar & hold until the collar is continuously flashing green

• Press & hold red (s), then press & hold black (s) at the same time

• This collar is now paired to the red (s) 

---

How It Works During Training

• The stimulation level is shared between both dogs

• Only the selected dog receives the signal

• Use the black (t) to switch between stim and vibrate mode

---

Important Notes

• Both dogs use the same stimulation level
  

• Always test collars before putting them on a dog